LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2010 >> Traverse LS, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 31 (Front Suspension System) >> Repair Instructions >> Lower Control Arm Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2009 Saturn Outlook, 2009 GMC Acadia, 2009 Chevrolet Traverse, and 2009 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Lower Control Arm
    GM1853091Courtesy of GENERAL MOTORS CORP.
  1. Position the front lower control arm in the frame.
    2. Fig 2: Identifying Front Lower Control Arm Nut
    GM1853070Courtesy of GENERAL MOTORS CORP.
  2. Install the front lower control arm rear nut (2) and bolt (1). Hand tighten the rear nut (2).
    3. CAUTION: Refer to Fastener Caution .
  3. Install the front lower control arm front nut (4) and the stud (3) and tighten to 195 N.m (144 lb ft).
    4. NOTE: Use the appropriate size wrench to hold the bolt while torquing the nut.
  4. Tighten the front rear lower control arm rear nut (2) to 150 N.m (111 lb ft).
    5. Fig 3: Identifying Lower Ball Joint Retaining Nut
    GM1853193Courtesy of GENERAL MOTORS CORP.
  5. Install the lower ball joint in the knuckle.
  6. Install the ball joint nut and tighten to 40 N.m (30 lb ft) plus 120 degrees.
  7. Install the outer tie rod end. Refer to Steering Linkage Outer Tie Rod Replacement .
  8. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  9. Remove the support and lower the vehicle.
scientia non olet · About LEMON Manuals