ECM Replacement

If the engine control module (ECM) is replaced, the following procedures must be performed:

NOTE:
When replacing the ECM, the ECM must be reset prior to removal. Failure to perform this procedure will result in the inability to:
• Test the ECM for warranty purposes.
• Install the ECM into other vehicles.
1. ECM reset procedure.
2. ECM reprogramming-Refer to Service Programming System (SPS) .
3. The Throttle Learn procedure-Refer to Throttle/Idle Learn .
4. The Crankshaft Position Variation Learn-Refer to Crankshaft Position System Variation Learn .
5. The Theft Deterrent Programming-Refer to Theft Deterrent Module Programming and Setup .