Electronic Brake Control Module Replacement and/or Reprogramming
WARNING: This page is about a different car, the 2010 Chevrolet Camaro. However, it is still accessible from the selected car via links, so may be relevant.
If the electronic brake control module (EBCM) needs to be replaced and/or reprogrammed, the following procedures must be performed:
- Connect a scan tool to the vehicle and access SPS. Refer to Service Programming System (SPS) .
- Perform the SPS function Electronic Brake Control Module - Programming and follow the on-screen instructions.
- Place the front wheels and steering wheel in the straight ahead position.
- Perform the SPS function Electronic Brake Control Module - Configuration & Setup and follow the on-screen instructions. Perform the following functions in this order:
- Programming
- Setup
- Clear DTCs after completing the programming procedure.