LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2011 >> Impala LT >> Repair and Diagnosis (Single Page) >> External Pages >> Different car >> Section 446 (Adjustable Pedal System) >> Repair Instructions >> Accelerator Pedal Assembly Replacement >> Installation Procedure
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Installation Procedure

WARNING: This page is about a different car, the 2007 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the accelerator assembly to the vehicle.
    NOTE: Refer to Fastener Notice .
  2. Install the accelerator mounting nuts to the accelerator bracket.

    Tighten:  Tighten the nuts to 10 N.m (89 lb in).

  3. Connect the accelerator pedal position sensor electrical connector.
  4. Confirm that the accelerator sensor connector locking clip is fully secured.
  5. Verify the operation of the accelerator pedal.
scientia non olet · About LEMON Manuals