Replace and Program the Front and Rear Parking Assist Control Module
WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
If the K41 Front and Rear Parking Assist Control Module needs to be replaced, the following procedures must be performed:
- Connect a scan tool to the vehicle and access SPS. Refer to Service Programming System (SPS)
- Perform the SPS function K41 Front and Rear Parking Assist Control Module Programming and follow the on-screen instructions.
- Perform the SPS function K41 Front and Rear Parking Assist Control Module Configuration and follow the on-screen instructions.
- Clear DTCs after completing the programming procedure.