Replace and Program EBCM or Reprogram EBCM

To program a replacement or an existing EBCM, perform the following procedure:

1. Install EL-49642  SPS Programming Support Tool. See Special Tools .
2. Access the Service Programming System (SPS) and follow the on-screen instructions.
3. On the SPS Supported Controllers screen, select Electronic Brake Control Module-Programming and follow the on-screen instructions.
4. On the SPS Supported Controllers screen, select Electronic Brake Control Module- Setup and follow the on-screen instructions.
5. At the end of programming, choose the "Clear All DTCs" function on the SPS screen.
6. With a scan tool access the EBCM, Configuration/Reset Functions, Electronic Brake Control Module Learn.
7. With a scan tool, access the EBCM, Configuration/Reset Functions, Brake Control Learn.
8. With a scan tool, access the Multi-Axis Acceleration Sensor Module, Configuration/Reset Functions, Yaw Rate Sensor Learn.