ECM Reprogramming

WARNING:

Replacement or reprogramming of the ECM, or replacement of the clutch pedal position sensor (CPPS) or clutch pedal requires that a CPPS learn procedure be performed. Failure to perform the CPPS learn procedure may result in personal injury or damage to the vehicle or its components if the vehicle is in gear and the starter motor is accidentally engaged.

NOTE:

After programming, perform the following to avoid future misdiagnosis:

Turn the ignition OFF for 30 s.
Turn the ignition ON with the engine OFF.
Use the scan tool in order to retrieve history DTCs from all modules.
Clear all history DTCs.

If the ECM needs to be reprogrammed, refer to Service Programming System (SPS) .
The Clutch Pedal Position Sensor Learn-Refer to Clutch Pedal Position Sensor Learn , for manual transmission - Tremec 6-Speed or Clutch Pedal Position Sensor Learn for manual transmission - Aisin AY6.
Engine Oil Life Remaining-When available, use a scan tool to reset the Engine Oil Life Remaining back to the original percentage recorded before the module was reprogrammed.
Transmission Fluid Life Remaining-When available, use a scan tool to reset the Transmission Fluid Life Remaining back to the original percentage recorded before the module was reprogrammed.