LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2012 >> Camaro LS, Automatic Trans >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Communication Devices >> Programming And Setup - All Systems >> Repair Instructions >> Head-Up Display Programming and Setup >> Head-Up Display Programming (ZL1 only)
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Head-Up Display Programming (ZL1 only)

To program and setup an existing or new replacement Head-Up Display, perform the following procedure:

  1. With a scan tool, access the Service Programming System (SPS) and follow the on-screen instructions. Refer to Service Programming System (SPS) .
  2. On the SPS Supported Controllers screen, select Head-Up Display - Programming and follow the on-screen instructions.

If the Head-Up Display fails to accept the program, verify all scan tool and Head-Up Display connections are secure.

NOTE:

After programming is completed, perform the following to avoid future misdiagnosis:

  1. Turn the ignition OFF for 10 seconds.
  2. Open and close the door.
  3. Connect the scan tool to the data link connector.
  4. Ignition ON, engine OFF.
  5. With a scan tool, clear all DTC's from all modules.
scientia non olet · About LEMON Manuals