LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2012 >> Caprice 6.0 2 >> Repair and Diagnosis >> Engine Mechanical >> Fuel System >> Engine Controls/Fuel - 6.0L - Repair Instructions >> Repair Instructions >> Accelerator Pedal Position Sensor Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    Fig 1: Identifying Accelerator Pedal To Steering Column Support Bracket Retaining Bolts
    GM1950792Courtesy of GENERAL MOTORS COMPANY
  1. Install the accelerator pedal to the steering column support bracket.
    2. CAUTION:

    Refer to Fastener Caution .

  2. Install the accelerator pedal to steering column support bracket retaining bolts (2) and tighten to 9 N.m (80 lb in).
  3. Connect the accelerator pedal sensor module electrical connector (1).
  4. Inspect for correct carpet fit under the accelerator pedal.
  5. If re-programming is required, refer to Control Module References .
  6. Install the left I/P on the lower closeout insulator panel. Refer to Knee Bolster Replacement .
scientia non olet · About LEMON Manuals