LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2012 >> Corvette Base, 2D Convertible, Automatic Trans >> Repair and Diagnosis (Single Page) >> Steering >> Steering Wheel And Steering Column >> Repair Instructions >> Steering Column Lock Control Module Replacement >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

    WARNING:

    Refer to SIR Warning .

  1. Disable the SIR system. Refer to SIR Disabling and Enabling .
    2. CAUTION:

    Avoid damaging the steering column electronic lock harness by gently removing the plugs installed in the I/P beam. Do NOT twist, pull, bend, cut, or incorrectly route the harness. Damage to the harness will require replacement of the entire electronic lock.

  2. Remove the I/P Assembly. Refer to Instrument Panel Assembly Replacement .
    3. Fig 1: Identifying Steering Column Electronic Lock Harness
    GM1400455Courtesy of GENERAL MOTORS COMPANY
  3. Disconnect the electrical connectors at the lock module (1).
    4. Fig 2: Identifying The Lock Module In The I/P Carrier
    GM1400454Courtesy of GENERAL MOTORS COMPANY
  4. Remove the lock module (1) by pulling the module up to release the retaining clips and sliding the module upward from the tie bar.
scientia non olet · About LEMON Manuals