Starting the Vehicle/ACC mode

To start a vehicle you must have a valid key fob present within the passenger compartment of the vehicle, the brake pedal depressed and the transmission in Park or Neutral. If there are no problems with key fob detection, the vehicle will be able to be started or put into accessory mode when the Start/ACC/OFF mode button is pressed. If a key fob is not detected or the radio frequencies are being interrupted, a message will display on the driver information center (DIC) stating NO FOB DETECTED. A NO FOB DETECTED message may be caused by a low transmitter battery or radio frequency (RF) interference from aftermarket devices such as 2-way radios, power inverters, cellular phone chargers, computers, etc. High RF traffic areas, such as gas stations which use pay-at-the-pump RF transponders, may also cause interference. A NO FOB DETECTED message caused by an aftermarket device or high RF traffic is considered normal and does not require the replacement of any components. Replacing components in these situations will typically not increase the performance of the system. Simply moving the fob to a different location inside the vehicle may allow key fob communication to continue. If moving the key fob within the vehicle does not correct the message, a pocket is located in the glove box for the key fob to slide into. The key fob must be inserted into the pocket bottom edge first with the buttons facing towards the passenger side of the vehicle. With the key fob inserted into the pocket correctly, a low frequency coupling will occur between the key fob and the antenna when the Start mode or ACC/OFF mode button is pressed. This procedure will put the vehicle in limp home mode and allow the vehicle to be operated.