October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.
Installation Procedure
Courtesy of GENERAL MOTORS COMPANY
- Apply a few drops of clean engine oil to the male pipe end.
Courtesy of GENERAL MOTORS COMPANY
- Push both sides of the quick-connect fitting together in order to cause the retaining feature to snap into place.
Courtesy of GENERAL MOTORS COMPANY
- Pull on both sides of the quick-connect fitting to make sure the connection is secure.
Courtesy of GENERAL MOTORS COMPANY
- Insert the tube in the connector until the retainer snaps in place.
- Push down on the redundant latch (1) until it is fully engaged and snapped into position.
Courtesy of GENERAL MOTORS COMPANY
- Insert the tube in the connector until the retainer snaps in place.
- Push down on the second latch (1) in order to secure the connection.
- Inspect for leaks using the following procedure:
- Turn the ignition ON, with the engine OFF for 2 seconds.
- Turn the ignition OFF, for 10 seconds.
- Turn the ignition ON, with the engine OFF for 2 seconds.
- Turn the ignition OFF.
- Inspect for leaks.