Installation Procedure
WARNING: This page is about a different car, the 2015 Cadillac SRX. However, it is still accessible from the selected car via links, so may be relevant.
- Install the wheel speed sensor connector retainer to the rear suspension cradle.
- Connect the wheel speed sensor electrical connector (1).
- Install the wheel speed sensor harness to the retainers (1).
- Install the wheel speed sensor (1) to the rear suspension knuckle.
- Install the wheel speed sensor bolt (1) and tighten to 9 N.m (80 lb in).
- Install the rear suspension link. Refer to Rear Suspension Link Replacement - Upper to Lower Control Arm .
- Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
- Perform the Diagnostic System Check - Vehicle .
CAUTION:
Refer to Fastener Caution .