Installation Procedure

WARNING: This page is about a different car, the 2010 Cadillac SRX. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying EBCM & BPMV

Courtesy of GENERAL MOTORS CORP.

Install the EBCM seals, if removed.
Install the EBCM (1) to the BPMV.

Fig 2: EBCM Bolts

Courtesy of GENERAL MOTORS CORP.

CAUTION: Refer to Fastener Caution .

Install the EBCM bolts (1) and tighten in a cross pattern to 3 N.m (27 lb in).

Fig 3: Identifying Master Cylinder Heat Shield Bolt

Courtesy of GENERAL MOTORS CORP.

Install the master cylinder heat shield, if equipped.
Install the master cylinder heat shield bolt (1) and tighten to 10 N.m (89 lb in).

Fig 4: Identifying Master Cylinder Heat Shield Nuts

Courtesy of GENERAL MOTORS CORP.

NOTE: Lift the dash panel insulator slightly to install the upper master cylinder heat shield nut.

Install the master cylinder heat shield nuts (1) and tighten to 25 N.m (18 lb ft).
Install the radiator surge tank. Refer to Radiator Surge Tank Replacement (LF1) or Radiator Surge Tank Replacement (LAU) .
If installing a new EBCM, program the EBCM. Refer to Control Module References .
Perform the Diagnostic System Check - Vehicle .