Installation Procedure
WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
- Position the ball joint on the lower control arm.
- Install the ball joint mounting nuts and bolts.
Tighten
Tighten the mounting nuts to 68 N.m (50 lb ft).
- Remove the lower control arm assembly from the vise.
- Install the lower control arm. Refer to Lower Control Arm Replacement .
- Check the front end alignment of the vehicle. Refer to Wheel Alignment Specifications .
CAUTION:
Refer to Fastener Caution .
NOTE:
When tightening the mounting nuts and bolts for the ball joint, hold the bolt and torque the nut for the proper torque measure.