Driver Seat Memory Switch
WARNING: This page is about a different car, the 2010 Cadillac SRX. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the harness connector at the S47D driver seat memory switch.
- Test for infinite resistance between the low reference terminal 1 and the signal terminals listed below with the switch in the open position.
- Terminal 5
- Terminal 6
- If not the specified value, replace the S47D driver seat memory switch.
- Test the resistance between terminal 1 and terminal 6 while pressing the memory 1 and memory 2 buttons. Compare the resistance readings to the values in the Memory Switch Values table below.
- If the resistance is not within the specified range, replace the S47D driver seat memory switch.
- Test for less than 1 Ω between terminal 1 and terminal 5 while pressing the memory set switch.
- If greater than the specified range, replace the S47D driver seat memory switch.
Memory Switch Values
| Switch Position | Resistance |
|---|---|
| Memory 1 | 570 - 698 Ω |
| Memory 2 | 1800 - 2209 Ω |