Front View Camera Module Programming and Setup

Front View Camera Module Programming and Setup

Front View Camera Module Replacement

If the Front View Camera Module needs to be replaced, the following procedures must be performed:

1. Connect a scan tool to the vehicle and access SPS. Refer to Service Programming System (SPS) Service Programming System (SPS).

2. Perform the SPS function Front View Camera Module - Programming and follow the on-screen instructions.

3. Calibrate the module. Refer to Front View Camera Module Calibration Front View Camera Module Calibration.

4. Clear DTCs after completing the programming procedure.

Front View Camera Module Reprogramming

Do not reprogram the Front View Camera Module, unless directed by a service procedure, or a service bulletin.

1. Connect a scan tool to the vehicle and access SPS. Refer to Service Programming System (SPS) Service Programming System (SPS).

2. Perform the SPS function Front View Camera Module - Programming and follow the on-screen instructions.

3. Calibrate the module. Refer to Front View Camera Module Calibration Front View Camera Module Calibration.

4. Clear DTCs after completing the programming procedure.