LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2013 >> Spark LS, Standard Trans >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Communication Devices >> Programming And Setup - All Systems >> Repair Instructions >> Multi-Axis Acceleration Sensor Module Programming and Setup >> Multi-Axis Acceleration Sensor Module Configuration
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Multi-Axis Acceleration Sensor Module Configuration

NOTE:

The Multi-axis Acceleration Sensor is also known as the Inertia Sensor Module (IMU) in SPS. The sensor must be configured using SPS before the vehicle Yaw Sensor Learn is performed.

A replacement Multi-axis Acceleration Sensor Module, requires the following procedure:

  1. Install EL-49642  SPS Programming Support Tool..
  2. Access the Service Programming System (SPS) and follow the on-screen instructions.
  3. On the SPS Supported Controllers screen, select IMU Inertia Sensor Module - Configuration and follow the on-screen instructions.
  4. At the end of programming, choose the "Clear All DTCs" function on the SPS screen.
  5. With a scan tool, perform the Yaw Sensor Learn. Refer to Vehicle Yaw Sensor Learn .
scientia non olet · About LEMON Manuals