LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2013 >> Traverse LS, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 189 (Power Door Lock System And Release Systems) >> Diagnostic Information and Procedures >> DTC B2495: Liftgate Latch Release/Cinch Malfunction >> Circuit/System Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Testing

WARNING: This page is about a different car, the 2015 Cadillac SRX. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the A23C Liftgate Latch Assembly. Ignition ON
  2. Connect a test lamp between the control circuit terminal 1 and control circuit terminal 3.
    3. NOTE:

    Liftgate must be completely closed and latched prior to performing test

  3. Verify the test lamp turns ON and OFF when pressing and releasing the S46B Liftgate Unlatch Switch
    • If the test lamp remains OFF 
    1. Ignition OFF, remove the test lamp, disconnect the X2 harness connector at the K39 Liftgate Control Module.
    2. Test for infinite resistance between each control circuit and ground.
      • If less than infinite resistance, repair the short to ground on the circuit.
      • If infinite resistance
    3. Test for less than 2 Ω in the control circuits end to end.
      • If 2 Ω or greater, repair the open/high resistance in the circuit.
      • If less than 2 Ω, replace the K39 Liftgate Control Module.
    • If the test lamp is always ON 
    1. Ignition OFF, remove the test lamp, disconnect the X2 harness connector at the K39 Liftgate Control Module, ignition ON.
    2. Test for less than 1 V between each control circuit and ground.
      • If 1 V or greater, repair the short to voltage on the circuit.
      • If less than 1 V, replace the K39 Liftgate Control Module
    • If the test lamp turns ON and Off 
  4. Replace the A23C Liftgate Latch Assembly .
scientia non olet · About LEMON Manuals