Installation Procedure
WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
- Position the front lower control arm (1) in the frame.
- Install the front lower control arm rear nut (2) and bolt (1). Hand tighten the rear nut (2).
- Install the front lower control arm front nut (4) to the stud (3) and tighten to 195 N.m (144 lb ft).
- Tighten the front rear lower control arm rear nut (2) to 150 N.m (111 lb ft)..
- Connect the lower ball joint in the knuckle.
- Install the ball joint nut and tighten to 50 N.m (37 lb ft) + (60-80 degrees).
- Connect the outer tie rod end. Refer to Steering Linkage Outer Tie Rod Replacement .
- Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
- Remove the support and lower the vehicle.
CAUTION:
Refer to Fastener Caution .
NOTE:
Use the appropriate size wrench to hold the bolt while torquing the nut.