Circuit/System Testing
WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, disconnect the harness connector at the appropriate rear window switch.
- Ignition ON, verify the scan tool LR Window Enable Cmd. and RR Window Enable Cmd. parameters are On.
- If not the specified value, press the window lockout switch on the driver master control.
- Test for greater than 9 volts between the control circuit terminal D and ground.
- If less than the specified range, test the control circuit for a short to ground or open/high resistance. If the circuit tests normal, replace the BCM.
- If all circuits test normal, replace the rear window switch.