Component Testing

Park Assist Switch

1. Ignition OFF, disconnect the harness connector at the S48E Multifunction Switch - Center Console.
2. Test for infinite resistance between the signal terminal 3 and the ground terminal 9 with the switch in the open position.
   • If less than infinite resistance 

     Replace the S48E Multifunction Switch - Center Console.

   • If infinite resistance 
3. Test for less than 10 Ω between the signal terminal 3 and the ground terminal 9 with the switch in the closed position.
   • If 10 Ω or greater 

     Replace the S48E Multifunction Switch - Center Console.

   • If less than 10 Ω 
4. All OK