Fuel Pump Control Module Programming

WARNING: This page is about a different car, the 2012 Chevrolet Volt. However, it is still accessible from the selected car via links, so may be relevant.

To program and setup an existing or new replacement fuel pump control module, perform the following procedure:

Access the Service Programming System (SPS) and follow the on-screen instructions.
On the SPS Supported Controllers screen, select FPCM Fuel Pump Flow Control Module - Programming and follow the on-screen instructions.

If the fuel pump control module fails to accept the program, verify all scan tool and fuel pump control module connections are secure.

NOTE:

After programming is completed, perform the following to avoid future misdiagnosis:

Turn the Vehicle OFF for 10 seconds.
Open and close the door.
Connect the scan tool to the data link connector.
Vehicle in Service Mode, engine OFF.
Clear all DTC's from all modules.