Installation Procedure
- Install the turn signal and multifunction switch assembly (2) to the steering column tilt head assembly.
- Install the 2 screws (1) to the turn signal and multifunction assembly and tighten to 3 N.m (27 lb in).
- Connect the turn signal and multifunction switch assembly connector.
- Install the upper and lower trim covers. Refer to Steering Column Trim Cover Replacement .
- Install the steering wheel. Refer to Steering Wheel Replacement .
- Enable the SIR system. Refer to SIR Disabling and Enabling .
CAUTION:
Refer to Fastener Caution .