LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2014 >> Traverse LTZ, AWD >> Repair and Diagnosis >> Accessories & Equipment >> Collision/Avoidance >> Object Detection System And Pedestrian Protection System >> Repair Instructions >> Rear Object Alarm Control Module Replacement
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Rear Object Alarm Control Module Replacement

Fig 1: View Of Object Alarm Module
GM1847695Courtesy of GENERAL MOTORS COMPANY
Rear Object Alarm Control Module Replacement

Callout Component Name

Preliminary Procedures

  1. Remove the left rear quarter lower trim panel. Refer to Quarter Lower Rear Trim Panel Replacement (Traverse with TB5) , Quarter Lower Rear Trim Panel Replacement (Traverse with TB4) , Quarter Lower Rear Trim Panel Replacement (Enclave with TB5) , Quarter Lower Rear Trim Panel Replacement (Enclave with TB4) , Quarter Lower Rear Trim Panel Replacement (Acadia with TB5) , Quarter Lower Rear Trim Panel Replacement (Acadia with TB4) .
  2. Remove the liftgate actuator (if equipped). Refer to Liftgate Actuator Replacement .
1 Communication Interface Module Bracket

Procedure

  1. Disconnect the body harness from the bracket as required.
  2. Loosen the bracket fasteners to remove the bracket from the slotted holes.
  3. Disconnect the electrical connectors.
2 Rear Object Alarm Module
Procedure 
Refer to Control Module References for programming and set up.
scientia non olet · About LEMON Manuals