LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2014 >> Trax LS, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 34 (Programming And Setup - All Systems) >> Repair Instructions >> Electronic Brake Control Module Programming and Setup >> Reprogram Electronic Brake Control Module
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Reprogram Electronic Brake Control Module

WARNING: This page is about a different car, the 2013 Chevrolet Trax and 2013 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.

To reprogram an existing Electronic Brake Control Module, perform the following procedure:

  1. Install EL-49642  SPS Programming Support Tool.
  2. Access the Service Programming System (SPS) and follow the on-screen instructions.
  3. On the SPS Supported Controllers screen, select Electronic Brake Control Module - Programming and follow the on-screen instructions.
  4. At the end of programming, choose the "Clear All DTCs" function on the SPS screen.
scientia non olet · About LEMON Manuals