USB Receptacle
WARNING: This page is about a different car, the 2015 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
- Verify the USB cable is properly connected at the X4 harness connector at the K74 Human Machine Interface Control Module.
- If connection problems or cable damage is noted.
Perform the appropriate repair or replacement to correct any issues.
- If no connection problems or cable damage is noted.
- If connection problems or cable damage is noted.
- Disconnect the vehicle USB cable X4 harness connector at the K74 Human Machine Interface Control Module.
- Connect the EL-50334-2 Type-A Female to Mini-B Male Cable to the K74 Human Machine Interface Control Module.
- Ignition ON, infotainment system ON.
- Connect the EL-50334-20 Multimedia Interface Tester (MIT) to the EL-50334-2 Type-A Female to Mini-B Male Cable and select the USB test mode.
- Verify the audio from the EL-50334-20 Multimedia Interface Tester (MIT) is heard through the infotainment system while operating the system to play audio from the test tool.
- If audio is not heard from the test tool
Replace the K74 Human Machine Interface Control Module.
- If audio is heard from the test tool
- If audio is not heard from the test tool
- Replace the USB cable assembly.