LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2015 >> Impala Limited LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 74 (Data Communication System) >> Diagnostic Information and Procedures >> DTC B101D: Electronic Control Unit Hardware >> Circuit/System Verification
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Verification

WARNING: This page is about a different car, the 2015 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition ON.
  2. Verify that DTC B101D is not set.
    • If DTC B101D is set in K9 Body Control Module with symptom byte F0 
    1. Verify that no other DTCs are set.
      • If no other DTCs are set
    2. Open the driver door to wake up the K9 Body Control Module.
    3. Ignition OFF, disconnect the battery negative cable and wait for 5 s.
    4. Reconnect the battery negative cable.
    5. Ignition ON, clear DTC B101D.
    6. Verify that DTC B101D is not set in K9 Body Control Module again.
      • If the DTC sets, replace the K9 Body Control Module.
      • If the DTC does not set
    7. All OK.
    • If DTC B101D is set in K9 Body Control Module with any symptom byte except F0 

      Replace the K9 Body Control Module.

    • If DTC B101D is set in other devices 

      Replace the device that set the DTC.

    • If DTC B101D is not set 
  3. All OK