Circuit/System Description

A 3-way catalyst controls emissions of hydrocarbons, carbon monoxide (CO) and oxides of nitrogen (NOx). The catalyst within the converter promotes a chemical reaction, which oxidizes the hydrocarbon(s) and the CO that are present in the exhaust gas. This process converts the hydrocarbon(s) and the CO into water vapor and carbon dioxide (CO2) and reduces the NOX, converting the NOx into nitrogen. The catalyst also stores oxygen. The engine control module (ECM) monitors this process by using a heated oxygen sensor (HO2S) that is in the exhaust stream after the three way catalyst. The HO2S 2 produces an output signal that the ECM uses to calculate the oxygen storage capacity of the catalyst. This indicates the ability of the catalyst to convert the exhaust emissions efficiently. The ECM monitors the efficiency of the catalyst by allowing the catalyst to heat, then wait for a stabilization period while the engine is idling. The ECM then adds and removes fuel while monitoring the HO2S 2. When the catalyst is functioning properly, the HO2S 2 response to the extra fuel is slow compared to the response of the HO2S 1, which is located before the three way catalyst. When the HO2S 2 response is near that of the HO2S 1, the oxygen storage capability and efficiency of the catalyst may be degraded below an acceptable threshold.