Circuit/System Testing
- Ignition OFF and all vehicle systems OFF, disconnect the harness connector at the S70R Steering Wheel Controls Switch - Right, ignition ON.
- Test for B+ between the 12V reference circuit terminal 1 and ground.
- If less than B+
- Ignition OFF, disconnect the harness connector at the K9 Body Control Module.
- Test for infinite resistance between the 12 V reference circuit and ground.
- If less than infinite resistance, repair the short to ground on the circuit.
- If infinite resistance
- Test for less than 2 Ω in the 12 V reference circuit end to end.
- If 2 Ω or greater, repair the open/high resistance in the circuit.
- If less than 2 Ω, replace the K9 Body Control Module.
- If B+
- Test for B+ between the 12 V reference circuit terminal 1 and signal circuit terminal 2.
- If less than B+
- Ignition OFF, disconnect the harness connector at the K9 Body Control Module.
- Test for less than 1 V between the signal circuit and ground.
- If 1 V or greater, repair the short to voltage on the circuit.
- If less than 1 V
- Test for less than 2 Ω in the signal circuit end to end.
- If 2 Ω or greater, repair the open/high resistance in the circuit.
- If less than 2 Ω replace the K9 body control module.
- If B+
- Ignition OFF, disconnect the X3 harness connector at the K9 Body Control Module.
- Test for infinite resistance between the S70R Steering Wheel Controls Switch - Right signal circuit terminal 2 and ground.
- If less than infinite resistance
Repair the short to ground on the circuit.
- If infinite resistance
- If less than infinite resistance
- Test or replace the S70R Steering Wheel Controls Switch - Right.