LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2015 >> Tahoe SSV >> Repair and Diagnosis >> Brakes >> Traction Control >> Antilock Brake System >> Repair Instructions >> Wheel Speed Sensor Reluctor Ring Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    Fig 1: Rear Wheel Speed Sensor/Reluctor Ring Installer
    GM4122432Courtesy of GENERAL MOTORS COMPANY
  1. Install the rear wheel speed sensor/reluctor ring, using J-45860  ring installer (1) and the J-8092  driver (2).
    2. Fig 2: Axle Shaft Bearing
    GM695758Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Ensure that the axle shaft bearing is fully seated in the rear axle shaft housing.

  2. Using the J-23690  installer (1) and the J-8092  driver (2), install the axle shaft bearing.
    3. Fig 3: Installing Axle Shaft Seal
    GM885624Courtesy of GENERAL MOTORS COMPANY
  3. Using the J-21128  installer, 8.6 and 9.5/9.76 inch axle, or the J-29173  installer, 9.5 inch axle, install the axle shaft seal.
  4. Drive the tool into the bore until the axle shaft seal bottoms flush with the tube.
  5. Install the rear axle shaft. Refer to Rear Axle Shaft Replacement .
  6. Install the rear axle housing cover. Refer to Rear Axle Housing Cover Replacement .
  7. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (6-Lug Wheel) .
  8. Fill the rear axle. Refer to Differential Oil Replacement (8.6 Inch Axle)Differential Oil Replacement (9.5/9.76 Inch Axle) .
  9. Remove the support and lower the vehicle.
scientia non olet · About LEMON Manuals