Replace and Program Control Module or Reprogram Control Module
To program a replacement or an existing control module, perform the following procedure:
- Access the Service Programming System (SPS) and follow the on-screen instructions.
- On the SPS Supported Controllers screen, select K36 Inflatable Restraint Sensing and Diagnostic Module - Programming and Setup and follow the on-screen instructions.
- At the end of programming, choose the "Clear All DTCs" function on the SPS screen.
NOTE:
After programming is complete, ensure Adaptive Cruise Control, Lane Keep Assist, and Advanced Parking Assist are all functioning properly if vehicle is equipped with features. If any of these systems are inoperative or not functioning correctly, perform the Yaw Rate Sensor Learn. The Yaw Rate Sensor Learn is located in the Configuration/Reset Functions GDS2 section, under Inflatable Restraint Sensing and Diagnostic Module.