Circuit/System Verification
- Ignition OFF for at least one minute to allow for the complete shutdown of the K71 Transmission Control Module. Ignition ON.
- Using a scan tool, erase the CVT calibration data in the TCM.
- Using a scan tool, run the CVT calibration process.
- Clear DTC P0863.
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data. The DTC should not set.
- If the DTC sets
Refer to Circuit/System Testing.
- If the DTC does not set
- If the DTC sets
- All OK.