LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2016 >> Spark LS, Standard Trans >> Repair and Diagnosis (Single Page) >> Electrical >> Body Electrical >> Wiring Systems And Power Management - Diagnostic Information And Procedures >> Diagnostic Information and Procedures >> DTC B1370-B1379, B1380-B1389, or B1440-B1443: Control Module Ignition ON and Start Circuit/Control Module Ignition Accessory Circuit/Control Module Ignition Off, Run, and Crank Circuit >> Component Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Component Testing

  1. Ignition OFF, disconnect the harness connector at the S39 Ignition Switch.
  2. Using the Resistance Test below, verify the resistance between the terminals listed below match for each S39 Ignition Switch position.
    • If any reading is other than specified 

      Replace the S39 Ignition Switch.

    • If the readings match 
  3. All OK.
Resistance Test

Ignition Switch Position Terminals 1 and 2 Terminals 2 and 3 Terminals 2 and 4 Terminals 2 and 6 Terminals 4 and 6
OFF Key Out Infinite Infinite Infinite Infinite Infinite
OFF Key In Infinite Infinite <5.0 Ω Infinite Infinite
ACCESSORY Infinite <5.0 Ω Infinite Infinite Infinite
ON/RUN <5.0 Ω <5.0 Ω Infinite Infinite <5.0 Ω
CRANK <5.0 Ω Infinite Infinite Infinite 1275-1325 Ω
scientia non olet · About LEMON Manuals