Replace and Program EBCM or Reprogram EBCM
WARNING: This page is about a different car, the 2015 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.
To program a replacement or an existing EBCM, perform the following procedure:
- Install EL-49642 SPS programming support tool.
- Access the Service Programming System (SPS) and follow the on-screen instructions.
- On the SPS Supported Controllers screen, select Electronic Brake Control Module-Programming and follow the on-screen instructions.
- On the SPS Supported Controllers screen, select Electronic Brake Control Module-Setup and follow the on-screen instructions.
- On the SPS Supported Controllers screen, select Electronic Brake Control Module-Configuration and follow the on-screen instructions.
- At the end of programming, choose the "Clear All DTCs" function on the SPS screen.