Replace and Program Control Module
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2015 GMC Yukon XL, 2015 GMC Yukon, 2015 Chevrolet Tahoe, 2015 Chevrolet Suburban, and 2015 Cadillac Escalade ESV. However, it is still accessible from the selected car via links, so may be relevant.
Do not reprogram the frontview camera module, unless directed by a service procedure, or a service bulletin.
To program a replacement or an existing frontview camera module, perform the following procedure:
- Access the Service Programming System (SPS) and follow the on-screen instructions.
- On the SPS Supported Controllers screen, select K109 Frontview Camera Module - Programming and follow the on-screen instructions.
- At the end of programming, choose the "Clear All DTCs" function on the SPS screen.
- Following K109 Frontview Camera Module programming, the module must be calibrated. Refer to Front View Camera Module Calibration .