Setup for Component Replacement - Fuel Pump Driver Control Module Configuration / Fuel Pump Power Control Module Configuration
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2015 GMC Yukon XL, 2015 GMC Yukon, 2015 Chevrolet Tahoe, 2015 Chevrolet Suburban, and 2015 Cadillac Escalade ESV. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition - On / Vehicle - In Service Mode - For 2 min
- Ignition/Vehicle - Off - For 2 min
- Ignition » On / Vehicle - In Service Mode
- Perform the following action: Cylinder Deactivation Exhaust Control Valve Learn (If applicable)
- Perform the following action: Clear the DTCs.
- Start Engine
- Verify DTC1005 is not set
If the DTC sets
- Perform the following action: Clear the DTCs.
- Ignition/Vehicle - Off - For 2 min
- Start Engine
- Verify the DTC does not set.
- If the DTC sets - Repeat the procedure starting at step 1
- If the DTC is not set - Configuration - Complete
If the DTC is not set
- Configuration - Complete