LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2016 >> Suburban 3500 HD LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 11 (Programming And Setup - All Systems) >> Repair Instructions >> Liftgate Control Module Programming and Setup >> Replace and Program Control Module
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Replace and Program Control Module

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2015 GMC Yukon XL, 2015 GMC Yukon, 2015 Chevrolet Tahoe, 2015 Chevrolet Suburban, and 2015 Cadillac Escalade ESV. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

Some vehicles may be equipped with the handsfree liftgate control option (TC2), it is important to select the correct calibration software for vehicles with or without this option as programming the liftgate with the incorrect software will cause the power liftgate system to become inoperative without any DTCs indicated

To program a replacement control module, perform the following procedure:

  1. Install EL-49642  SPS Programming Support Tool.
  2. Access the Service Programming System (SPS) and follow the on-screen instructions.
  3. On the SPS Supported Controllers screen, select Liftgate Control Module - Programming and follow the on-screen instructions.
  4. At the end of programming, choose the "Clear All DTCs" function on the SPS screen.
  5. With a scan tool, perform the Liftgate Relearn. Refer to Liftgate Calibration
scientia non olet · About LEMON Manuals