Replace and Program Control Module or Reprogram Control Module

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2015 GMC Yukon XL, 2015 GMC Yukon, 2015 Chevrolet Tahoe, 2015 Chevrolet Suburban, and 2015 Cadillac Escalade ESV. However, it is still accessible from the selected car via links, so may be relevant.

To program a replacement control module, perform the following procedure:

Access the Service Programming System (SPS) and follow the on-screen instructions.
On the SPS Supported Controllers screen, select SEQ Programming Sequence Seat Belt Retractor Motor Module - Left/Right (M101L/M101R) and follow the on-screen instructions.
At the end of programming, choose the "Clear All DTCs" function on the SPS screen.