Circuit/System Verification
- Ignition ON.
- Verify the rearview camera has no debris on the lens and that the bezel and bezel seal are not damaged.
- If debris is found on the lens
Clean the lens. If the lens, bezel, or bezel seal are damaged, replace as necessary.
- If no debris on the lens
- If debris is found on the lens
- Engine running, transmission in REVERSE.
- Verify the backup lamps are illuminated.
- If the backup lamps are not illuminated
Refer to Backup Lamps Malfunction (Automatic transmission)Backup Lamps Malfunction (Manual Transmission) .
- If the backup lamps are illuminated
- If the backup lamps are not illuminated
- Engine running, transmission in REVERSE.
- Verify a clear rear vision image is displayed on the P17 Info Display Module.
- If a clear image is not displayed
Refer to Circuit/System Testing.
- If a clear image is displayed
- If a clear image is not displayed
- All OK.