Circuit/System Verification
- Vehicle in Service Mode.
- Verify which module set this DTC using the scan tool vehicle wide DTC check.
- If DTC set in the Hybrid/EV Powertrain Control Module 2 only
Refer to P06E4 in Data Communications
- If DTC set in the ECM only
Replace the K20 Engine Control Module then perform repair verification.
- If the DTC sets in both modules
Diagnose the K114B Hybrid/EV Powertrain Control Module 2 first.
- If DTC set in the Hybrid/EV Powertrain Control Module 2 only
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.