Circuit/System Verification
- Verify DTCs that inhibit Autostop operation, or stuck clutch DTCs P07A3 or P07A5, or pressure controls solenoid DTCs P0960, P0962, or P0963 are not set.
- If any of the DTCs are set
Refer to Diagnostic Trouble Code (DTC) List - Vehicle .
- If none of the DTCs are set
- If any of the DTCs are set
- Verify DTC P3260 is not set.
- If the DTC is set
- Program the T6 Power Inverter Module.
- Vehicle ON, verify the DTC does not set.
- If the DTC sets, replace the T6 Power Inverter Module.
- If the DTC is not set
- All OK.
NOTE:The transmission must be in Neutral for greater than 33 seconds.
- If the DTC is not set
- All OK.