Replace and Program Control Module or Reprogram Control Module

CAUTION:

DO NOT program the power line communication module with the drive motor battery charger cable connected to the vehicle. Charging the drive motor battery while programming may result in damage to the DC charging contactors.

To program a replacement or an existing control module, perform the following procedure:

Install EL-49642 SPS Programming Support Tool.
Access the Service Programming System (SPS) and follow the on-screen instructions.
On the SPS Supported Controllers screen, select Power Line Communication Module - Programming and follow the on-screen instructions.
At the end of programming, choose the Clear All DTCs function on the SPS screen