Circuit/System Verification
- Ignition ON.
- Verify DTC B1405 is not set.
- If the DTC is set
Refer to DTC B1405
- If the DTC is not set
- If the DTC is set
- Verify DTC B0958 01, B0959 01, B0960 01, B0961 01, B0958 21, B0959 21, B0960 21 or B0961 21 is not set.
- If any of the DTCs are set
- Verify none of the B78 Rear Object Sensors are contaminated with snow, mud, dirt, slush, or ice.
- If contaminated, clean the B78 Rear Object Sensors.
- If there is no contamination.
- Refer to Circuit/System Testing.
- If none of the DTCs are set
- Verify that DTC B0958 3A, B0959 3A, B0960 3A or B0961 3A is not set.
- If any of the DTCs are set
Replace the appropriate B78 Rear Object Sensor with the correct sensor type.
- If none of the DTCs are set
- If any of the DTCs are set
- Ignition ON, transmission in R.
- Verify the scan tool Parking Assist System Status parameter is Enabled.
- If the Parking Assist System Status parameter is Disabled
Refer to Circuit/System Testing.
- If the Parking Assist System Status parameter is Enabled
- If the Parking Assist System Status parameter is Disabled
- All OK.