Circuit/System Verification
- Ignition ON, clear the DTC information with a scan tool.
- Verify that DTC P0641 or P0651 does not set.
- If any of the DTCs are set
Refer to DTC P0641 or P0651 (ECM) for further diagnosis.
- If none of the DTCs are set
- If any of the DTCs are set
- Verify DTC P0602 is not set.
- If the DTC is set
- Program the K20 Engine Control Module. Refer to Control Module References .
- Verify DTC P0602 is not set.
- If the DTC is set, replace the K20 Engine Control Module.
- If the DTC is not set
- All OK.
- If the DTC is not set
- Verify DTC P0601, P0603, P0604, P0606, P0607, P060D, P062F, or P2610 is not set.
- If any of the DTCs are set
Replace the K20 Engine Control Module.
- If none of the DTCs are set
- If any of the DTCs are set
- All OK.