Circuit/System Verification
- A short to voltage on other components may cause DTC P0690 to set. If any other DTC is set, diagnose that DTC first.
- If you were sent here from Engine Cranks But Does Not Run, proceed to Circuit/System Testing.
- Ignition ON, observe the scan tool DTC information. Verify DTC DTC P0685, P0690, or P1682 is not set.
- If any of the DTCs are set
Refer to Circuit/System Testing.
- If none of the DTCs are set
- If any of the DTCs are set
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
- If the DTC sets
Refer to Circuit/System Testing.
- If the DTC does not set
- If the DTC sets
- All OK.
NOTE: