Replace and Program Control Module or Reprogram Control Module

This control module does not require SPS programming or any setup procedures.

This control module does not require SPS programming but does require the following setup procedures after a new control module is installed:

To program a replacement or an existing control module, perform the following procedure:

1. Install EL-49642  SPS Programming Support Tool.
2. Access the Service Programming System (SPS) and follow the on-screen instructions.
3. On the SPS Supported Controllers screen, select K109 Frontview Camera Module - Programming and follow the on-screen instructions.
4. At the end of programming, choose the "Clear All DTCs" function on the SPS screen.
5. Perform the Frontview Camera Module Calibration. Refer to Front View Camera Module Learn .