LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2017 >> Traverse LS, AWD >> Repair and Diagnosis >> Engine Mechanical >> Fuel System >> Engine Controls And Fuel - 3.6L (LLT) - Repair Instructions >> Repair Instructions >> Accelerator Pedal Position Sensor Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    Fig 1: APP Sensor Bolts & Sensor
    GM1858232Courtesy of GENERAL MOTORS COMPANY
  1. Install the upper bolt into the APP sensor assembly.
  2. Install the APP sensor assembly into the vehicle.
    3. CAUTION:

    Refer to Fastener Caution .

  3. Install the remaining 2 lower APP sensor assembly bolts.

    Tighten 

    Tighten the bolts to 8 N.m (71 lb in).

    4. Fig 2: Accelerator Pedal Position Sensor Assembly
    GM1858231Courtesy of GENERAL MOTORS COMPANY
  4. Install the I/P wiring harness electrical connector (2) to the APP sensor assembly.
  5. Install the driver knee bolster. Refer to Driver Knee Bolster Replacement (Acadia)Driver Knee Bolster Replacement (Enclave)Driver Knee Bolster Replacement (Traverse) .
  6. Install the left I/P insulator. Refer to Instrument Panel Insulator Panel Replacement - Left Side .
scientia non olet · About LEMON Manuals