Antenna Coaxial Cable Replacement - Communication Interface Module to Navigational Signal Splitter

WARNING: This page is about a different car, the 2019 Chevrolet Traverse. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedure Instrument Panel Assembly Replacement
1	Antenna Coaxial Cable - Communication Interface Module to Navigational Signal Splitter Procedure Disconnect the electrical connectors. If the antenna cable is taped into the wiring harness, cut the ends off the old antenna and route the new antenna as close to the old one as possible using tie straps to secure the new cable.

Callout

Component Name

Preliminary Procedure
Instrument Panel Assembly Replacement

Antenna Coaxial Cable - Communication Interface Module to Navigational Signal Splitter

Procedure

Disconnect the electrical connectors.
If the antenna cable is taped into the wiring harness, cut the ends off the old antenna and route the new antenna as close to the old one as possible using tie straps to secure the new cable.