Installation Procedure
- CAUTION:
Refer to Component Fastener Tightening Caution .
NOTE:High pressure fuel feed pipes are one time use only. ALWAYS install a NEW high pressure fuel feed pipe if the pipe is removed OR the fittings are loosened.
To install the NEW fuel feed intermediate pipe (6) perform the following steps:
- Hand tighten the fuel feed intermediate pipe fitting (2) to the fuel injection fuel rail (3).
- Hand tighten the fuel feed intermediate pipe fitting (5) to the fuel pump (4).
- Tighten the fuel feed intermediate pipe fittings (2, 5) to 30 N.m (22 lb ft).
- Install the fuel feed intermediate pipe bolt (1) and tighten to 10 N.m (89 lb in).
Position the air cleaner resonator bracket (2).
- Install the air cleaner resonator bracket bolt (1) and tighten to 9 N.m (80 lb in).
- Wiring Harness Clip (3) - Install
- Connect the battery negative cable. Battery Negative Cable Disconnection and Connection
- Inspect for leaks using the following procedure:
- Turn ON the ignition with the engine OFF for 2 seconds.
- Turn OFF the ignition for 10 seconds.
- Turn ON the ignition with the engine OFF.
- Inspect for fuel leaks.
- Air Cleaner Outlet Duct - Install - Air Cleaner Outlet Duct Replacement
- Intake Manifold Cover - Install - Intake Manifold Cover Replacement
CAUTION:
Refer to Fastener Caution .
WARNING:
Fuel escapes - observe safety measures and national legislation. Failure to comply could result in personal injury.